Fillet weld grinder KNS 150-E

Easy-to-use features

• Two-level transmission reduction for an extremely high removal rate


• The flanges are made of stainless steel and can support discs with 22, 23 or 25.4 mm bores in different widths


• Adjustment wheel for pre-selecting the correct speed


• Stepless adjustment to the optimal speed range for the products being applied


• Tool-free adjustment of the protective cover for adapting to different applications in seconds


• The extension arm is made of anodised aluminium. No contamination occurs if part of the power tool comes into contact with the stainless steel workpiece

Straightforward to use

• The extremely flat design enables sanding in hard-to-reaches areas, on railings, fillet welds and in container construction


• The winding protective grille protects the motor from abrasion


• Maximised service life and optimum surface results

Powerful and safe

• Electronic monitoring of the winding temperature. Light signal in the event of overload


• The 1,200 W motor with feedback control and soft start function enables rapid work progress, as the speed remains constant even under load


• Anti-restart function prevents the fillet weld grinder from restarting unintentionally after a power interruption, thereby reducing the risk of injury