For detailed information, other images and documents, please select individual articles from the following table.
Adhesive for plastics REPLAST® Easy Superfast
For REPLAST® Easy plastic repair sets
Register now and access more than 125,000 products
Variants
Register now and access more than 125,000 products
An adhesive for any type of plastic
- No need to use different types of adhesive
- Can be used for repairs and structural gluing
Special static mixer
- Excellent mixing ratio
- Low adhesion loss (waste)
Fast hardening
Additional operations, like smoothing, can be performed after a very short period of time
Excellent chemical resistance
Resistant to a wide range of liquids, like petrol, various lubricating oils and ethyl acetate
Solvent-free
Due to the release agents used during plastic processing, adhesion problems may be created in certain cases. Not suitable for PE (polyethylene), PP (polypropylene) or PTFE (polytetrafluoroethylene). If necessary, check the compatibility of the material in an inconspicuous area.
The usage instructions are recommendations based on the tests we have conducted and are based on our experience; carry out your own tests before each application. We do not assume any liability for a specific application result due to the large number of applications and storage/usage conditions. We do not assume any liability for any technical information or advice provided free of charge by our customer service. Therefore, before using the product, anyone intending to make use of it must determine whether it is suitable for its planned use and, in any case, assumes all liability that may derive from its use. We ensure the consistent quality of our products. We reserve the right to make technical changes and other developments.
Passenger cars
Spoiler, grille and radiator slots, door fastening elements, bumpers and headlight bracket slots
Heavy vehicles and buses/coaches
Bumpers, wheel arches and plastic intake pipes.
Motorbikes
All panels
The sub-layer must be able to support loads and must be clean, dry and free from grease and rust. Eliminate any old adhesive residues. To this end, clean the surface with the plastic cleaner and apply the primer. The drying time must be observed. Extrude and eliminate the first unmixed adhesive part and then assemble the stirrer. The first 2 cm of adhesive must not be used for gluing. During application, the stirrer tip must stay immersed in the adhesive to prevent bubbles from forming. Follow the instructions for use.
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!